Re: Re: Circuit design (quick fix)

Posted by Roy on October 31, 2003 at 12:40:52:

In Reply to: Re: Circuit design posted by kelley pace on October 29, 2003 at 13:08:53:

Kelley,

Thank for the descriptive circuit. Until such time that this fully matures an easy stop gap measure would be to wire in a high quality single pole changeover switch. One way would be RUN, effectively leaving the bias pot wired normally. The other way IDLE would switch in a resistor of suitable value in series with the bias pot.

Roy

DISCLAIMER: Do not try this unless you are qualified to do so. This work involves working with mains voltages and you could electrocute yourself or others if the work is not done in a competent manner.

Follow Ups:

Post a Followup

Name    : 
E-Mail  : 
Subject : 

Comments:

Optional Link URL : 
Link Title        : 
Optional Image URL: