Apparently my other pictures did not come through on my last post. I was attempting to attach a couple photos to show John the custom bent “z” metal where the panel will reside in the frames.
The one picture that came through shows how we welded the “Z” metal to the vertical post. It’s a little difficult to make out but, we punched 1/2” holes in the Z metal and then welded through the holes to attach the Z metal to the vertical steel supports.
Then, as shown in one of my previous posts with my hillbilly hand drawn diagram (attachment), I will have a plate that bolts to the Z metal to grip and hold the panel in place. I do not have a good picture of the yet.
There is also a flange welded to the bottom of the Z metal that will support the panel.