Reply To: Pristine II restoration

home Forums General Discussion Pristine II restoration Reply To: Pristine II restoration

#755
yoshi
Participant

    Chungjh has a good point. You should be measuring across the variable pot. My reaction is that 1.6 ohms seems low. If that’s the correct measured value, I would only say that a fixed resistor will sound cleaner and more open that the measured equivalent on the variable pot. For a small cost, I might suggest you buy a few values, 4 and 3 ohms( 50 watt, non conductive) and the 4 ohm a try. If you want more treble, then consider to go down to a 3 ohm and solder that value in place.

    Good luck, I do look forward to your
    Feedback on the treble sound change.

    Ken